Connection and Interfaces

Connections and Interfaces

DL1TXV2, General Connections

Aux: For future functions (Not activated).

COM5: TTL serial 3.3V port for Mavlink output or transparent protocol and device communication.

Power Switch: ON/OFF switch for DL1TXV2.

RCBUS: Communications between XLRS devices.

USB (Micro B): PC connection for Mavlink or transparent protocol, device communication through the COM port, update firmware and battery charge.

Wifi: (In preparation) For Mavlink or transparent protocol and device communication.

Encoder with Push Button: Configuration parameters of the device.DL1RX, General Connections

Power Input: 5V. Min 4,5V. Max 6Vcc. | Consumption: Standby 70mA. | Max consumption: TX(500mW) 540mA @12mS.

RCBUS: Serial communication XLRS devices.

Radio Modem: Serial Port, Transparent Data Link / Mavlink Telemetry. | In the aircraft or vehicle connect the «MODEM» port (GND, TX, RX) of the DL1RX receiver to the «TELEM» telemetry port of the autopilot (Pixhawk, APM…) or to the data port of other devices (UC, Arduino, Rapberry…).