Device Connection

The Device Connection window appears right when the program starts, as the first step is to connect to a SATPRO.

You can open it at any time from the menu.

Initial Setup:

• The first time you receive a SATPRO, the Ethernet configuration may not be suitable for your network, requiring reconfiguration. Therefore, you will need to connect via the COM port initially.
• Install Driver: Download and install the Silicon Labs CP210x driver.

Steps for COM Port Connection:

1. Enter COM Port Number:
   • Enter the COM port number (preferably <10) and select “Open Com”.
   • If the connection is successful, you will immediately see commands and responses moving in the console.
2. Review Ethernet Configuration:
   • After establishing a COM connection, review and configure the Ethernet settings.

Preferred Connection:

• Once Ethernet is configured, it is preferable to use UDP or TCP connections over the COM port. These are more secure and provide smoother operation than the COM port.
• Ethernet Cable: It is better to use an Ethernet connection cable rather than the RCBus for SATPRO, reserving RCBus for firmware updates or when an Ethernet connection is not possible.

Port Configuration:

• SATPRO Ports: Ports range from 8000 to 8007.
• UDP Local Ports: Typically range from 9000 to 9007, but other ports can be used.

Connection Types:

• UDP Connection: Lightweight and creates fewer issues compared to TCP.
• TCP Connection: More secure and better for remote or distant environments.

You can switch between modes on the fly. The application will prompt for confirmation when changing the port.

Additional Information:

• For more detailed information on configuring Ethernet and other settings, refer to the relevant sections in the documentation or the help menu within the application.